Following the Government’s instruction regarding the national coronavirus emergency, Starrett UK closed on the 24th March until further notice. We look forward to continuing trade when possible to do so. All orders placed on and after this date will unfortunately not be shipped. If you would like to continue with your order we will have it delivered as soon as restrictions are lifted and it is safe to do so. If you have any questions at all please fill in an enquiry form on our contact us page - but in the meantime, stay safe everyone.

A simple, but highly effective method of ejecting the core from a hole saw after completion of the cut.

  • Select the appropriate size of ejector for the hole saw.
  • Where it is necessary to assemble the two parts of the core ejector, twist the spring on to the ejector plate until it locks in place.
  • Twist the spring on the assembled core ejector over the pilot drill until the pilot drill is protruding from the plate.
  • Drill the hole.
  • Please note that using the core ejector will reduce the cutting depth of the saw. The table below lists the recommended optimum maximum material thickness for each type of hole saw. The core ejector will function at greater material thicknesses than those listed, however its effectiveness will diminish. 

  Assembled core ejector attached to a hole saw.                         After the hole has been drilled, the core can clearly be seen at the end of the pilot drill.

Core Ejector Cutting Recommendations 

Hole Saw
Product Code

Recommended Maximum
Material Thickness

FCH, DCH, CT 7mm

D and MPH 5mm

Please note:

In some applications it is possible that the core may be ejected from the saw at high speed. Please always use safety goggles and glasses and take extra care if drilling vertically.